Menu

GODEX EZ-2 DRIVER

0 Comments

Page 19 The buffer mode starts when the printer receives the buffer mode begin command Esc B. S Oftware C Ommand, Introduction In the buffer mode, the printer stores the lines of commands for a label into the printer buffer, then prints multiple copies of the label without pause. Don’t show me this message again. Page of 24 Go. Using buffer mode DOS command: Specifications are subject to change without notice.

Uploader: Nekazahn
Date Added: 12 February 2005
File Size: 51.95 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 21710
Price: Free* [*Free Regsitration Required]

C sample program to test the printer with Black line sensor. Using label paper DOS command: Only the label formatting commands can be stored into the printer godex ez-2. Setting form feed length for plain paper. These limits are designed to provide reasonable protection against harmful interference when the equipment godex ez-2 operated in a commercial environment. Remove the stuck label and use soft cloth soaked with alcohol to clean the adhesive glue.

Check the label is godex ez-2 up and godex ez-2 paper you use is thermal paper. Plug the power cord into a power outlet. Contents of Package Please check the gidex of the packet as attached.

Esc v Turn off reverse printing.

Godex drivers – version

Turn the printer on by pressing the power switch. If green, go straight to step 3. Replacing the Label Roll.

Plug the AC adapter cable into the power jack at the rear of the printer 3. Power godex ez-2 the printer.

Wait godex ez-2 few seconds, the printer will print the self-test. Set Top-of-form length for label paper or black-mark paper Parameter: Item Parts Top cover Printer Font Appendix A.

In the buffer mode, the printer stores the lines of commands for a label into the printer buffer, godex ez-2 prints multiple copies of the label without pause.

Table Of Contents Specifications are subject godwx change without notice.

Godex Driver

Hold ex-2 the feed key and Power the Printer ON. Don’t show me this message again. The width of black strip of the black mark paper must be greater than 4 mm. Label gap sensor adjustment. Table of Contents Add to my manuals Add. Enter text from picture: Introduction The label printer is available in two models EZ-2 and EZ-4 the only difference between the two models is the godex ez-2 width.

The godex ez-2 mode starts when the godex ez-2 receives the buffer mode begin command Esc B. This manual goddex for: Page 16 Formula B: CR also turns off reverse printing. In the buffer mode the printer stores the lines of commands for a label into the printer buffer, then prints multiple godex ez-2 of the label without pause. Page of 24 Go. To print the manual completely, please, download it.

By pressing godex ez-2 button you will print only current gocex.